You can, however, modify it for your own use. I designed this and it is protected by copyright rules and cannot be reproduced & re-sold do not share do not create and sell this item. Open that - and then the STL will be within for use. Once you pay, you will get fast access from Etsy to download the file. ALSO - you have this file - so you can move the holes/add holes if you need to!! Just don't sell my design - even if you "re-make it". There is a link down below for the exact feet I used to mount my laser so you can print those too - which will put your laser exactly the right spot as I have designed here. The distance of the bottom of this part to the center of the screw holes that go into the rear laser rail is 47mm. **IF your laser's feet are sitting on top of holders that are attached to the spoilboard, you may need to add a spacer - or washer under this printable mount in order to screw it to your spoilboard. I also have a hole built in if you wanted to screw in an M5 bolt/screw to tighten up the vertical rail. My result was very secure yet slides in easily. But I printed it using 0.20 layer, no supports, on a Prusa MK3S+. Tolerances vary depending on your printer. I designed it and am using it with the v slot rails linked below. It is attached using up to size M5 screws & drop in T nuts to the back of the laser frame (see photos). So, the v slot rail slips into the mount & rests on the spoilboard. This accommodates the SOLID aluminum rails and hardware.
(I didn't want an all-plastic frame because I felt it wasn't solid enough). HOWEVER - I have links to the other parts you will need below to assemble EXACTLY what I have made in the photographs. The only part file included here is the one circled in RED. ALSO - you can modify the STL file FOR YOUR OWN USE (NOT TO BE SOLD OR GIVEN AWAY). It will also work with the XTool D1 - IF you DRILL holes through the rear frame.
A 3d printable STL file that you can print for attaching a Lightburn camera mount (made of aluminum v slot rails) to the back of your Ortur Laser Master (2 & pro) Laser.
0 kommentar(er)
